I did bed calibration as per instructions in this forum, and have done it multiple times since. The only thing that's changed is the firmware. I'm also using the same version of Simplif圓D. Note that I'm using the same cartridges and glue sticks that produced successful prints over the last week. Since then, I've been unable to get a single clean print - nothing will adhere to the bed. Two days ago I replaced the stock firmware with Repetier 0.92 for DaVinci. ![]() Even then I was able to salvage the other objects I'd ganged up. After a week and about 20 prints, I only had one instance where a print had issues, and that was a with a multicolor print that released from the base and started knocking around. ![]() Two days in I purchased Simplif圓D 2.2 to avoid dealing with XYZWare and have been very happy with it. I was able to immediately get reasonable prints using the XYZ Filament and the glue stick method. ![]() I bought my Davinci Duo about 10 days ago.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |